Page 2 of 2
Re: Fabricating a 2P badge
Posted: Wed Oct 23, 2019 2:13 am
by nama
Hi,
No I never got around to it.
To many other things to do
Re: Fabricating a 2P badge
Posted: Thu May 27, 2021 9:33 pm
by billdrom
Just for completeness here is my Challenger III badge.
The badge itself is 51 mm high and 340 mm long.
The lettering is 11 mm high. The first letter is 14 mm from the left edge of the badge and 18 mm from the bottom of the badge.
The switch edge is 15 mm from the right edge of the badge.
- Challenger III logo.jpg (175.42 KiB) Viewed 16968 times
Re: Fabricating a 2P badge
Posted: Fri Aug 16, 2024 12:19 am
by doperst2@gmail.com
Not intending to steal a post, but the font is Neil Bold.
Re: Fabricating a 2P badge
Posted: Fri Aug 16, 2024 4:29 pm
by HOWARDHB
Thanks for the font info.
Now I can 3D print the emblem!
Re: Fabricating a 2P badge
Posted: Sun Aug 18, 2024 4:53 pm
by dave
doperst2@gmail.com wrote: ↑Fri Aug 16, 2024 12:19 am
Not intending to steal a post, but the font is Neil Bold.
Wow, that's great info. Thanks!
Re: Fabricating a 2P badge
Posted: Sun Aug 18, 2024 6:03 pm
by doperst2@gmail.com
Welcome to my introduction post, btw.
viewtopic.php?t=903
There is a pic of my case with the logo.